|
FEATURES / ADVANTAGES
- High abrasion resistant floor
hardener giving a maintenance free
floor.
- Bonds monolithically to the base
concrete and ensures a hard wearing
surface.
- Resistant to oil and greases.
- Easy and economical to apply.
TYPICAL APPLICATION
- For areas subjected to heavy
wear and tear.
- Can also be used on areas subjected
to heaviest traffic such as : loading
bays, work shops, machine shops,
ramps spill ways etc.
TYPICAL CHARACTERISTICS
Nature
|
:
|
Single component powder |
Colour
|
:
|
Natural cement
grey |
(Pot life)at 25°C
|
:
|
Approx 45 minutes |
ENGINEERING DATA
|
|
|
Specification Complies |
:
|
BS784 1953, BS 1881 Part 4,
1970 Clause 2
IS 1237 198: ASTM E-97
|
|
Abrasion resistance |
: |
It improves
the abrasive resistance of the
concrete by 150%. |
Light
Reflectance
|
:
|
Colour
Natural
Brick Red
Green
|
Reflectance
30- 35%
10 -15%
10 15% |
|
Compressive strength (N/mm²
) 28 days cure |
: |
50 |
DIRECTIONS
FOR USE
Concrete mix should be designed to
minimize segregation and bleeding.
The base concrete should have minimum
cement content of 300 Kg/ m3 OR M-20
Grade of concrete
Water : Cement ratio should be always
less than 0.54. Slump should be 70
to 100 mm.
If required use water reducing agent
Masterpalst PL-1. It is recommended
that the floor be marked off into
bays of known area. Sufficient material
then be laid out to meet the required
spread rates. This is applied in two
application states
(The first application is made by
using ½ to 2/3 of the material
required for eventual and use). This
is evenly broad caste on to the concrete
surface. When the material becomes
uniformly dark by the absorption of
moisture from the concrete this application
can be floated. Wooden floats or on
large areas, the power trowel with
disc may be used. It is important,
however that the surface is not over-worked.
Immediately after floating the remaining
materials is thrown evenly over the
surface. Again moisture is absorbed
and the surface can be floated in
the same way as before.
Final finishing of the floor using
the power trowel with blades can be
carried out when the floor has stiffened
so that damage will not be caused.
TECHFLOOR HT- 200
(Spl.) is applied at different rates
per m² to provide floor
surfaces suitable for different types
of industrial use.
| Application
rate Kg/sq.m |
Intended
traffic use |
|
7.0 |
Heavy |
| 5.0 |
Medium |
| 3.0 |
Light |
CLEANING OF TOOLS & EQUIPMENTS:
Tools and Equipments can be cleaned
with water.
STORAGE AND SHELF LIFE
If kept in original, undamaged
packing the shelf life of this product
should be at least one year.
PACKING: 30 Kg.
PRECAUTIONS:
- While application, whereby edges
are likely to suffer particularly
heavy
impact of wear, those can be given
additional protection.
- Timing of the application is
very important.
- If any eye contamination then
should be washed immediately with
plenty
of water and medical advice sought.
|
